Sinopower Transformer Begins Commissioning New Vacuum Casting Line in Changzhou
Sinopower Transformer is installing and commissioning a new automated vacuum casting line at its manufacturing facility in Changzhou. The line is one part of the company’s 2026 production upgrade and is intended for the manufacture of cast-resin dry-type transformers.

Assembly and initial testing are now underway. Engineers and production employees are checking the equipment and adjusting the process before it enters regular operation. The investment is intended to improve process control and manufacturing consistency while supporting additional production capacity. Its effect on output, yield and delivery schedules will be evaluated after commissioning and production validation are complete.


Why Vacuum Casting Matters
In a cast-resin dry-type transformer, the winding and insulation system must be produced under carefully controlled conditions. Moisture, trapped air, mixing accuracy, temperature and vacuum level can all influence the quality of the finished casting.
A vacuum casting process prepares, meters and mixes resin materials before casting them under reduced pressure. The controlled environment is designed to limit moisture, impurities and air pockets in the insulation system. Achieving a stable result also depends on material handling, process settings, tooling, curing and inspection; the casting machine is an important part of the process, but it is not the only factor.
This distinction matters to the Sinopower production team. Rather than treating the arrival of new equipment as the end of the project, employees are using the commissioning period to check each stage and establish repeatable operating parameters.


Automated Metering and Process Monitoring
According to the company’s equipment specification, the new line incorporates film-degassing technology, metering-pump components and a three-level metering-monitoring system. Material preparation, dosing and mixing are automated, while the casting process takes place under high vacuum.
These functions are designed to improve dosing accuracy and help operators maintain consistent process conditions from one casting cycle to the next. Precise temperature control and degassing are also intended to support the insulation performance of the finished windings and help control partial discharge.
Sinopower has set an internal qualification-rate target of 99.9% for cast components after the line reaches stable operation. This figure is a production target, not a published result from completed mass-production runs. It will need to be confirmed through actual operating records, inspection data and the company’s applicable quality procedures.


From Installation to Production Validation
The equipment has completed installation and an initial round of adjustments. The current work focuses on commissioning rather than full production. During this stage, the team will verify operating steps, monitoring functions and process stability before the line is incorporated into normal manufacturing.
The new casting system follows other equipment introduced by Sinopower in 2026, including automated winding equipment and high-voltage foil-winding equipment. Together, these additions are intended to increase automation in selected manufacturing processes and provide more consistent control over production timing.
For customers, the practical value of the investment will depend on verified production results. Sinopower plans to assess quality consistency, throughput and scheduling performance after the equipment has operated under normal production conditions. Product performance and delivery arrangements will continue to be confirmed against the technical and commercial requirements of each order.


A Measured Step in a Longer Manufacturing Program
Sinopower Transformer has worked in power-transformer manufacturing for 16 years. Over that period, equipment, materials and customer requirements have continued to change. The new vacuum casting line reflects the company’s current focus on dry-type transformer manufacturing and on making key processes more controlled and repeatable.
On the factory floor, that work is still practical and unfinished. Cables are being connected, settings are being checked and employees are preparing for trial operation. The line will only move into regular production after the required commissioning and validation work has been completed.
For Sinopower, the installation is not presented as an instant transformation. It is one concrete step in an ongoing effort to improve how products are made, inspected and prepared for customers.












